Analysis of the application and waterproof problem of LED outdoor wall washer

With the continuous development of the lighting industry, the technological application of lamps and lanterns is also constantly improving. There are more and better choices for the material selection of lamps and lanterns. There has also been a great improvement in the improvement of light source and power utilization. Lamps and light sources use high-tech, long-life, low-voltage, safe, and environmentally-friendly lighting fixtures. Let’s talk about outdoor LED wall washers.
         General LED wall washers are mostly used in outdoor projects. For example, bridge lighting and other lighting to brighten the beautiful scenery; there is also building floor lighting; because LED wall washer is an LED light source; the effect achieved is more diverse; it can be colorful, and you can use the controller to control the effect you want; red, green and blue Yellow, white, warm, white, colorful gradients and other effects can be controlled manually; all the functions of this outdoor lighting wall washer are very many; the main lighting effect can be known within the expected.
  Because outdoor LED wall washers are used in construction projects such as buildings and bridges, they have been exposed to wind and rain outdoors for many years, and maintenance and installation are not easy. Therefore, the waterproof problem of outdoor LED wall washers cannot be ignored. Important links, the following points should be paid attention to in terms of waterproofing:
1. Material selection is very important. Take the wall washer as an example, the section thickness of the profile should be at least 2mm or more. On the contrary, if it is too thin like a blade, it will damage the silicone pad in the cover.
2. There is a certain gap between the width of the glass and the profile (that is, the glass is slightly narrower). When applying glue in this way, press the glass hard, and the glue will emerge from the gap to achieve a perfect full state and better waterproof
3. Of course, it is exquisite workmanship.
During the production of LEDER lighting, or when changing a production process, a set of empty shells will be assembled in advance, and each suspicious water inlet point will be filled with paper towels (such as the contact surface between glass and profiles, plugging screw holes, and outlet holes) for soaking. water test. After soaking for a certain period of time, check where the paper towel is wet.